Hobbymate HB800-FBL V 2.0 Gyro has an aluminum composite design casing.

Its slight di­men­sions allow it to be installed in practically any model helicopter. HB800-FBL can be installed horizontally as well as vertically.

The sensory system is based on the newest MEMS technology.

Software with sophisticated sensor data processing makes installation in electrical & nitro model helicopters possible.

With an optional adapter cable, HB800-FBL can also be utilized solely as a tail gyro.

This is recommended especially for whoever is switching from the conventional paddle system and wants to slowly approach the RIGID operation with the 3 axle solution (3G-Gyro Mode).

The well-thought-out and easy setup goes smoothly with no need of an expensive programming box or computer.

This makes it easy to still change a number of settings even at the airfield.

Moreover HB800-FBL integrated swashplate mixer enables the use of simple remote control systems which do not have their own swashplate mixing (NO-MIX).

HB800-FBL is able to process many types of sum signals (PPM / S-BUS / Spektrum).

With the optional Spektrum Satellite Adapter, installation in indoor model helicopters is also possible without a great number of wires

Operating voltage: 3,5V...8,5 V DC (Lipo 2s possible)

Temperature range: -15°C bis +40°C

Processor: 32Bit ARM

Analog processing: 17Bit

Sensor technology: 2 MEMS angular rate sensors

Adjustable servo center pulse width:
Tail: 760μs / 960μs / 1520μs

Adjustable servo pulse rate:
Tail: 50 Hz / 165 Hz / 270 Hz / 330 Hz / 560 Hz
Swashplate: 50 Hz / 65 Hz / 120 Hz / 200 Hz

Build-in swashplate mixer:
Mechanical / 90° / 120° / 140° /

Serial pulse input:
PPM / S-BUS / SRXL / Spektrum-satellite

Size: 34 x 25 x 13,5 mm
Weight without cable: approx. 20 g

Manual did not comes with gyro package, but available in PDF file, contact if you buy this device